start:hype_file_reference:classdata.txt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
start:hype_file_reference:classdata.txt [2024/02/21 10:14] cpers [File content] |
start:hype_file_reference:classdata.txt [2024/02/21 10:23] (current) cpers [File content] |
||
|---|---|---|---|
| Line 41: | Line 41: | ||
| |traveltime |//-// |time of travel |Scaling factor for the class toime of travel in relation to the reference time of travel | | |traveltime |//-// |time of travel |Scaling factor for the class toime of travel in relation to the reference time of travel | | ||
| |tilegroup |//-// |tile type group |An integer 0,1,2,…, 10. Determines which classes are to have reduced tile drainage based on fraction of drained area. 0=no reductions, 1=reduction based on fraction for tile group 1, etc. | | |tilegroup |//-// |tile type group |An integer 0,1,2,…, 10. Determines which classes are to have reduced tile drainage based on fraction of drained area. 0=no reductions, 1=reduction based on fraction for tile group 1, etc. | | ||
| - | |redischarge |//-// |recharge or discharge class |Between -1 and 1. Positive values for discharge classes and negative values for recharge classes of the modeloption redischarge model. Limitation: recharge classes need to have lower **class** values than all discharge classes.| | + | |redischarge |//-// |recharge or discharge class |Positive values for discharge classes and negative values (of fraction of class that is recharge area) for recharge classes. Limitation: recharge classes need to have lower **class** values than all discharge classes.| |
| </sortable> | </sortable> | ||
start/hype_file_reference/classdata.txt.txt · Last modified: 2024/02/21 10:23 by cpers
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
