This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
start:hype_file_reference:glacierdata.txt [2017/04/26 18:14] cpers |
start:hype_file_reference:glacierdata.txt [2018/02/14 15:57] cpers |
||
---|---|---|---|
Line 27: | Line 27: | ||
^ Variable ID ^ Unit ^ Description ^ | ^ Variable ID ^ Unit ^ Description ^ | ||
|''subid''|//-//|subbasin ID (integer) (mandatory)| | |''subid''|//-//|subbasin ID (integer) (mandatory)| | ||
- | |''glactype''|//0/1//|The default type is glacier (0), the alternative type is ice cap (1)| | + | |''glactype''|//0/1/2/3//|The default glacier type is mountain glacier (0). The alternatives are; (1) ice cap (same equations different parameters), (2) ice sheet (same as ice cap except that the area is constant), and (3) infinit glacier (glacier melt independent of state).| |
|''logvolcorr''|//-//|correction of volume-area relationship coefficient due to combining several glaciers into one class area (no correction=0)| | |''logvolcorr''|//-//|correction of volume-area relationship coefficient due to combining several glaciers into one class area (no correction=0)| | ||
|''slcdate''|//YYYYMMDD//|date for which glacier slc-fraction is representative| | |''slcdate''|//YYYYMMDD//|date for which glacier slc-fraction is representative| | ||
|''annualmb''|//mm/yr//|annual mass balance for correction of initial volume| | |''annualmb''|//mm/yr//|annual mass balance for correction of initial volume| | ||
+ | |''slcvolume''|//m<sup>3</sup>//|The initial glacier volume (at ''slcdate'' and with ''annualmb'' if these are set). Default is not to use slcvolume (-9999). It overrides the glacier state from the state file.| | ||
</sortable> | </sortable> | ||